New European daylight standard requiring average levels of around 1.5 times higher than current guidance is likely to cause a significant shift in the design of residential dwellings. Rallou Nikolaou discusses how developers should tackle the period of change.
Daylight is proven to have a multitude of benefits including for health, wellbeing and mood. It is therefore an important and desirable factor for buildings; particularly in dwellings or any space people tend to occupy for long periods of time, such as work places.
Daylight levels in such developments are currently subject to local and national guidance; however, UK-wide legislation - incorporated into Building Regulations - has been lacking. Instead, the BRE Guide 'Site layout planning for daylight and sunlight: A guide to good practice' is widely accepted and used to determine planning applications.
Recognising this gap, the first daylighting European Standard EN-17037 ‘Daylight of buildings’ was officially published and came into effect in December 2018. This specifies minimum recommendations for new developments covering daylight provision, view out, exposure to sunlight and protection from glare.
The new standard requires a median daylight factor of 2.1%. Compared to current recommendations this means that an Average Daylight Factor (ADF) of around 1.5 times higher would be required for compliance.
This is likely to be difficult to achieve, especially for dwellings in dense urban areas where basements or conversions are common. Architects would need to further optimise designs through glazing and internal layouts to achieve it, causing a potential increase in design costs and / or reducing achievable development densities and hindering housing delivery.
To address this, a National Annex is currently being drafted to accompany the EN Standard and set alternative target values and methodologies to apply in the UK. Once completed, there will be a re-write of the BRE Guide; currently heading for a publication date of 2020.
These changes have the potential for a big effect on the residential sector and may require the design process to undergo a considerable shift. It is thought that only around 30% of current dwellings in the UK would comply under the new standard.
However, with no clear timeframes there is a sense of ambiguity over when the new European Standard will become part of planning policy; creating uncertainty that could lead to different planning applications being approved or rejected despite having similar designs and meeting the same requirements.
Developers should ensure daylight is integrated into the very first stages of the design process and so it will become increasingly important to liaise with a good planning consultant, architect and sustainability consultant in the early stages; especially on projects where planning applications are not expected until after 2020, due to the risk that current design will not meet future requirements.
The increase in daylight will need to be considered in conjunction with energy usage and risk of overheating. If not managed correctly, the additional glazing can cause unwanted solar gains and heat losses, affecting both the energy performance and thermal comfort of a building.
RPS’ sustainability and energy consultants can advise on how to ensure buildings achieve optimum daylight levels without increasing the risk of overheating and the energy consumption of the building.
Principal Consultant - Energy and SustainabilityFind out about RPS' sustainability and energy consultants
Your contact information:
All fields are mandatory *
Your message has been submitted successfully.
We aim to respond to all enquiries within 48 hours.
If your enquiry is urgent - please contact your local office.
An error occurred. Please refresh the page and try again.